Scattered petals necklace

At first I used round wire to make different sizes of jump rings. As you can see figure 1 below the round jump rings from big to small. I decided to make three jump rings with the square bar wire as you can see figure 2 below, and I added small round jump rings to complete the necklace.

Figure 1- Mthethwa, F., (2020). Petal necklace, sterling silver.

Figure 2- Mthethwa, F., (2020). Petal necklace, sterling silver.

Figure 2 shows first improvement of the scattered petals necklace.

Figure 3- Mthethwa, F., (2020). Oval links, sterling silver.

I made oval links that will be soldered at the back of the scattered petals necklace. The oval link that is in front was slightly bent so that it could fit in between the rose petals.

Figure 4- Mthethwa, F., (2020). Oval links, sterling silver.

In figure 4, shows the rose petals were ready for soldering. The oval links will be soldered on the back of the rose petals because they were fragile without the link.

Figure 5- Mthethwa, F., (2020). Scattered petals necklace, sterling silver.

Figure 5 shows the back of the scattered petals necklace. 

Figure 6- Mthethwa, F., (2020). Scattered petal necklace, sterling silver.

Figure 6 shows the first improvement of the scattered petals necklace.